Zebra Xi IIIPlus Firmware v60.13.0.9
Expected Release Date
? 28 October 2004
? This firmware is for the Z4Mplus, Z6Mplus, 90Xi3+, 110Xi3+, 140Xi3+, 170Xi3+, 220Xi3+,
PAX4, and some 105SL printers. It includes the 300 dpi 220Xi3+ printer and the 200 dpi
170Xi3+. It is based off of the V60.13.0.1 firmware from the existing Xi3+ printer line.
? Includes all features of previous V60.13.0.# releases
? V60.13.0.7 & V60.13.0.8 were not released
♦ New Features
For printers with Real Time Clock support, enhancements have been completed which include
user configurable control of Real Time Clock label updating.
♦ Issues Addressed
Issue 1
AUTOEXEC.ZPL functions correctly from Compact Flash - A drive
Issue 2
Corrected logic error for an invalid parameter check with the ^SL command of the enhanced Real Time Clock. An
invalid first parameter of -1 in the ^SL command could stall printing.
Issue 3
Corrected issue with enhanced Real Time Clock where if formatting a label takes longer than RTC
accuracy setting the label may not print.
Issue 4
Corrected spelling mistake in the "Printer Ready" prompt in Japanese.
♦ PAX 4 Issues Addressed
Issue 4
For PAX4 -Cover open and RTS errors will now stop auto-calibration & will flash the error LED.
Issue 5
The ribbon LED value will be defaulted to a value that will detect a ribbon out condition.
Issue 6
Added a check so that if the machine type is set as a non-PAX and there is a RTS (ribbon tension system)
detected it will not be active.
Issue 7
Firmware now uses FPGA load 57 (shown on configuration label) to fix a problem on the 110PAX4 printer to allow
the Ribbon Tension System to display values greater then 128 for the TAKE-UP or SUPPLY ARM.
Zebra Xi IIIPlus |
||||||||||||
|
||||||||||||
